Dry Method: For smaller decals approx. 10 inches and under
1. Clean surface with mild soapy water or rubbing alcohol
2. Remove backing from decal
3. Place decal sticky side to the outside of the desired surface
4. Rub down with a squeegie
5. Remove transfer tape
Wet Method: For Larger decals approx. 10 inches and over and windshield banners
1. Clean surface with mild soapy water or rubbing alcohol
* Prep area with our Installation Solution or a large spray bottle with water and 3-4 drops of dish soap, towels and a squeegie.
2. Remove backing from decal, spray the sticky side of the decal lightly
- this will allow you to slide the decal around on the surface before drying. You may also want to lightly spray the surface too. -- Be careful to do this inside a garage or on a warm sunny day for best results. DO NOT apply on a cold, rainy or windy day.
3. Place decal sticky side to the outside of the desired surface
4. Rub down with a squeegie, make sure to remove excess solution with the towels
5. Let stand and dry for 10-15 min.
6. Remove transfer tape
Hinge Method: For Larger decals
