Clean surface with mild soapy water or rubbing alcohol
2.
Remove backing from decal
3.
Place decal sticky side to the outside of the desired surface
4.
Rub down with a squeegie
5.
Remove transfer tape, enjoy decal!
Wet Method:
For Larger decals approx. 10 inches and over and windshield banners
1.
Clean surface with mild soapy water or rubbing alcohol. * Prep area with our Installation Solution or a large spray bottle with water and 3-4 drops of dish soap, towels and a squeegie
2.
Remove backing from decal, spray the sticky side of the decal lightly
- this will allow you to slide the decal around on the surface before drying. You may also want to lightly spray the surface too. -- Be careful to do this inside a garage or on a warm sunny day for best results. DO NOT apply on a cold, rainy or windy day
3.
Place decal sticky side to the outside of the desired surface
4.
Rub down with a squeegie, make sure to remove excess solution with the towels
5.
Let stand and dry for 10-15 min., Remove transfer tape, enjoy decal!
Hinge Method:
For Larger decals
1.
Clean surface with mild soapy water or rubbing alcohol. * Prep area with our Installation Tape, razor blade or scissors and a squeegie
2.
Position decal where you would like to install it and Place tape over decal onto window above and below decal to create a "hinge"
3.
Peel back the backing on one side of the decal till you get to the hinge and carefully cut the paper backing off at center then lightly squeegie down the decal to the window going from the center outward
4.
Repeat other side, paper backing will already be cut so will easily detach from the transfer tape
5.
Rub down decalwith squeegie a final time then remove transfer tape from decal, enjoy decal!
Please contact us if you have any questions or problems installing your decal.
